What this video covers
Replacing a broken hydraulic brake lever on the F2.2 Pro (and similar hydraulic setups).
Steps
- Loosen the brake-lever retaining-pin locking bolt, then push the main retaining pin out from the bottom (pry from the top if needed).
- Loosen the bottom actuator-pin locking bolt, unscrew the actuator pin, and remove the old lever.
- Push the new actuator-pin housing into the new lever, align the threads, and screw the lever in until the retaining-pin holes line up.
- Insert the retaining pin and tighten its locking bolt.
- Adjust the silver actuator pin so the brake sensor fully presses and releases, then tighten the actuator-pin bolt.
- Test: rear wheel off the ground, give a tiny amount of throttle and squeeze the new lever — the power should cut out. If it doesn't, readjust the silver actuator bolt.